The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing event in life. You’re looking forward to the exercise you’ll obtain from using it. Possibly you’re a little relieved to have lastly made a selection from the various designs you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Generally, the cover that gets back with your new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence due to the fact that as soon as it is put in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are very small as they increase from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.

It takes place gradually and on a Swim Spa Cover which is made from private areas, at varying speeds. So eventually you’ll discover one or two of the areas are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much aid since you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a new style for their Swim Spa Covers
Instead of using numerous foam panels to build Swim Spa Covers that will eventually end up in some landfill, they developed one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to buy today, bookmark this site so you can find it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *